Introduction

Most of the replaceable components in a laptop is through the back panel. Therefore, this guide will show how to remove it properly.

Use the plastic opening tool to remove the gray rubber pads on the bottom of the laptop. For our device we only needed to remove the two at the top.
  • Use the plastic opening tool to remove the gray rubber pads on the bottom of the laptop. For our device we only needed to remove the two at the top.

Add Comment

Use a Torx T5 head to remove the six 5.1 mm screws.
  • Use a Torx T5 head to remove the six 5.1 mm screws.

  • Use a JIS J1 to remove the two 7.2mm screws.

Add Comment

  • Use Plastic opening tool to pry open the case. Go slowly around the edge. You will hear popping noises, such are due to popping open the small joints that keep the cover attached.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Matthew Martin

Member since: 10/10/2017

501 Reputation

5 Guides authored

Team

USF Tampa, Team S13-G17, Cagle Fall 2017 Member of USF Tampa, Team S13-G17, Cagle Fall 2017

USFT-CAGLE-F17S13G17

4 Members

7 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 2

Past 30 Days: 27

All Time: 277