HP Compaq NC6120 Monitor Replacement

You're viewing a previously published version of this guide. View latest version

Jun 23, 2015 - 02:11:41

Jun 23, 2015 - 02:11:41 Jun 23, 2015 - 02:09:43 Jun 23, 2015 - 02:09:42 May 26, 2015 - 04:13:21 May 26, 2015 - 12:23:18 May 07, 2015 - 12:23:12 May 06, 2015 - 11:55:55 May 06, 2015 - 11:00:41 May 06, 2015 - 10:58:43 May 06, 2015 - 10:57:22 May 06, 2015 - 10:55:04 May 06, 2015 - 10:53:59 May 06, 2015 - 10:52:12 May 06, 2015 - 10:45:40 May 06, 2015 - 10:28:46 May 06, 2015 - 08:46:32 May 06, 2015 - 08:44:22 May 06, 2015 - 08:43:00 May 06, 2015 - 08:39:40 May 06, 2015 - 08:38:13 May 06, 2015 - 08:37:39 May 06, 2015 - 08:37:05 May 06, 2015 - 08:36:05 May 06, 2015 - 08:35:18 May 06, 2015 - 08:35:17 May 06, 2015 - 08:33:23 May 06, 2015 - 08:24:11 May 06, 2015 - 08:23:19 May 06, 2015 - 08:16:51 May 06, 2015 - 08:16:08 May 04, 2015 - 01:27:03 May 04, 2015 - 01:27:02 May 04, 2015 - 01:26:20 May 04, 2015 - 01:26:16 May 04, 2015 - 01:26:15 May 04, 2015 - 01:25:22 May 04, 2015 - 01:25:21 May 04, 2015 - 01:24:51 May 04, 2015 - 01:24:50 May 04, 2015 - 01:23:28 May 04, 2015 - 01:22:15 May 04, 2015 - 01:22:15 May 04, 2015 - 01:21:05 May 04, 2015 - 01:18:36 May 04, 2015 - 12:48:30 May 04, 2015 - 12:34:01 May 04, 2015 - 12:30:57 May 04, 2015 - 12:28:48 May 04, 2015 - 12:28:23 May 04, 2015 - 12:26:01 May 04, 2015 - 12:25:09 May 04, 2015 - 12:25:08 May 04, 2015 - 12:19:51

Newer

Introduction

Should the monitor of the laptop stop functioning correctly, you may need to replace the monitor altogether. This is a simple replacement that can be done by removing a few easy screws.

What you need

Step 1 Monitor

HP Compaq NC6120 Monitor Replacement, Monitor: step 1, image 1 of 2

HP Compaq NC6120 Monitor Replacement, Monitor: step 1, image 2 of 2

Locate and remove four black 5.1mm Phillips #1 screws from the left and right sides of the monitor.

Step 2

HP Compaq NC6120 Monitor Replacement: step 2, image 3 of 3

Using a small spudger, remove the four black plastic covers from above the monitor, revealing screws underneath.

Step 3

Remove the four screws that were just uncovered. They are 6.2mm 3.0 flathead screws.

Step 4

Pry off the plastic case surrounding the monitor.
A spudger may be needed to pry off the case.

Step 5

HP Compaq NC6120 Monitor Replacement: step 5, image 3 of 3

Remove the black and silver cable, located directly below the monitor.
Proceed to pull monitor approximately 10cm away from the back of the laptop case.