Graco Secure Coverage Nursery Unit Power Jack Replacement

Step 1 Nursery Unit Battery




• Remove the 9mm screw from the battery cover of the nursery unit using a Phillips #1 tip screwdriver.
Step 2



• Using the plastic opening tool, pry and remove the battery cover carefully.
• Remove the batteries using plastic opening tool.
• Replace the batteries.
Step 3 Nursery Unit Power Jack
• Remove the two 9mm Phillips #1 screws from the rare case of the device.
• Place the screws in a secure place.
Step 4
• Hold the bottom of the device with one hand and pull down to separate the front and rare cases.
• While holding the device with one hand, use plastic opening tool to pry the edges of the front case away from the back case.
• Take your time and apply constant force carefully to avoid breaking any other plastic parts from the device.
Step 5
• Remove all three 7mm Phillips #1 screws from the mother board.
• Make sure you gently unscrew the screws with moderate force and light pressure to avoid any damages.
Step 6
• Pick up the mother board carefully.
• Using plastic opening tool, gently pry the power jack plastic part and separate it away from the device case.
• Apply constant force to avoid breaking the plastic part.
Step 7
• Solder off the wires from the mother board.
• There are many pins attached to the mother board, make sure you solder off the proper pins that attached to the power jack wires.
• Replace the power jack.

Author

with 2 other contributors

Omar Abdullah

Member since: 09/06/15

201 Reputation

2 Guides authored

Badges: 6

• 
• 
• 

+3 more badges

Team

USF Tampa, Team 6-5, Remmell Fall 2015 Member of USF Tampa, Team 6-5, Remmell Fall 2015

USFT-REMMELL-F15S6G5

4 Members

8 Guides authored

Embed this guide

Choose a size and copy the code below to embed this guide as a small widget on your site / forum.

Preview