Introduction

The shell on the RC Mustang GT is mostly a cosmetic component, giving the car the unique appearance associated with GEAR'D UP's RC cars. The following steps will show how to replace the shell of the car.

Parts

No parts required.

Flip the car over and remove the four 5mm Phillips #0 screws that hold the shell to the car chassis. Flip the car over and remove the four 5mm Phillips #0 screws that hold the shell to the car chassis.
  • Flip the car over and remove the four 5mm Phillips #0 screws that hold the shell to the car chassis.

Add Comment

Flip the car over again to its upright position and vertically lift the shell from the car.
  • Flip the car over again to its upright position and vertically lift the shell from the car.

  • During re-assembly, make sure the shell is correctly aligned. If it is not aligned correctly, it may rub on the wheels, possibly preventing them from turning.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Claudia Robinson

Member since: 02/01/2015

347 Reputation

3 Guides authored

Team

Cal Poly, Team 8-38, Amido Winter 2015 Member of Cal Poly, Team 8-38, Amido Winter 2015

CPSU-AMIDO-W15S8G38

4 Members

8 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 2

All Time: 121