Locate the four screws in the four corners of the back panel.
  • Locate the four screws in the four corners of the back panel.

Add Comment

Using a T10 Torx Screwdriver, begin unscrewing the  four 11.0 mm  screws from the back panel.
  • Using a T10 Torx Screwdriver, begin unscrewing the four 11.0 mm screws from the back panel.

Add Comment

Using a plastic opening tool or similar object, find the groove in the side of the device and begin prying open the back panel. Work the tool around the entire panel until it pops off.
  • Using a plastic opening tool or similar object, find the groove in the side of the device and begin prying open the back panel. Work the tool around the entire panel until it pops off.

Add Comment

Lift the beige clamp using a tweezer or your fingernail and remove the connector.
  • Lift the beige clamp using a tweezer or your fingernail and remove the connector.

Add Comment

Lift the connector gently from the socket.
  • Lift the connector gently from the socket.

Add Comment

Lift and separate the speaker connector cable using a pair of tweezers.
  • Lift and separate the speaker connector cable using a pair of tweezers.

Add Comment

Gently lift the speaker out of the back cover using a plastic opening tool.
  • Gently lift the speaker out of the back cover using a plastic opening tool.

  • Apply force as needed if there is glue holding the speaker in place.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Ricardo Audain

Member since: 09/07/2016

551 Reputation

5 Guides authored

Team

USF Tampa, Team 6-4, Remmell Fall 2016 Member of USF Tampa, Team 6-4, Remmell Fall 2016

USFT-REMMELL-F16S6G4

4 Members

5 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 2

Past 7 Days: 2

Past 30 Days: 8

All Time: 44