Introduction

After too many charging cycles, the battery's capacity will be decreased. This is true for any Lithium-ion battery. Luckily the replacement of the battery in this device is very simple.

Parts

No parts required.

  1. To open up the casing, you will need to unscrew the four Phillips #0 15mm screws which are accessible from the back.
    • To open up the casing, you will need to unscrew the four Phillips #0 15mm screws which are accessible from the back.

    Add Comment

  2. Gently separate the two halves of the casing.
    • Gently separate the two halves of the casing.

    Add Comment

    • Disconnect the battery from the motherboard by lifting up on the white plastic tab on the top of the connection.

    • Gently pull the cord out by the white plastic adapter. Do not pull from the red and black cord.

    Add Comment

    • Unscrew the Phillips four #0 15mm screws to free the motherboard from the casing.

    Add Comment

    • Slowly pull the motherboard out of the casing. Make sure the loose battery wire doesn't get snagged.

    Add Comment

    • Remove the four #0 15mm screws to release the battery housing from the case.

    Add Comment

    • Take the battery housing and battery out of the casing.

    Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Vladislav Ignatov

Member since: 09/23/2014

369 Reputation

3 Guides authored

Team

USF Tampa, Team 12-5, Blackwell Fall 2014 Member of USF Tampa, Team 12-5, Blackwell Fall 2014

USFT-BLACKWELL-F14S12G5

4 Members

6 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 410