Introduction
If the accessory holder is no longer able to hold the multiple tools associated with the vacuum, this guide outlines the its replacement.
What you need
-
-
On the back of the vacuum, pull the handle connected to the hose away from the vacuum.
-
-
-
-
Using a T15 Torx Security Screwdriver, remove the screw on each side of the indention in which the hose normally rests.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.