Introduction
The spinning brushes are located on the backside of the DEEBOT D35 on the front right and left edge. These brushes pull dirt to the vacuum where it is suctioned up.
What you need
-
-
Roll the Deebot over on a flat surface. The brushes will be located on the front with bright yellow connectors.
-
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Team
USF Tampa, Team 12-2, Eyestone Spring 2017 Member of USF Tampa, Team 12-2, Eyestone Spring 2017
USFT-EYESTONE-S17S12G2
4 Members
4 Guides authored
One Comment
Where can I get a replacement part for the little gray piece on step 3?
