Introduction

You will need a phillips head screw driver and needle nose pliers to complete this task. Before opening the device, ensure that there is no power to avoid damaging the electronics or harming yourself.

Disconnect any power source and/or turn off device.
  • Disconnect any power source and/or turn off device.

Add Comment

Remove the 15 rubber plugs from the cavities using needle nose pliers.
  • Remove the 15 rubber plugs from the cavities using needle nose pliers.

Add Comment

Use a phillips head screwdriver to remove the fifteen 6.4mm screws.
  • Use a phillips head screwdriver to remove the fifteen 6.4mm screws.

Add Comment

Carefully separate the two sections of the frame.
  • Carefully separate the two sections of the frame.

  • Wires still connect the two sections. Be cautious to avoid damaging the wires, terminals, and electronics.

Add Comment

Inspect the gasket around the perimeter of the frame. Remove the gasket using your fingers or needle nose pliers.
  • Inspect the gasket around the perimeter of the frame. Remove the gasket using your fingers or needle nose pliers.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

James Lipsett

Member since: 03/20/2017

601 Reputation

6 Guides authored

Team

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 4

All Time: 51