Disassembling the Nokia 6300

Written By: LucasJV (and 4 other contributors)

Comments: 1
Favorites: 15
Completions: 19

Difficulty

Easy

Steps

Time Required

5 - 10 minutes

Introduction

Disassembling the Nokia 6300 is not very hard and if you know how to disassemble other Nokia phones this will be very easy. You need a Torx T6 screwdriver.

Tools

Buy these tools

T6 Torx Screwdriver

$6.99

Buy

Parts

No parts specified.

Step 1 Rear Cover

Take off the back cover by pushing it down and sliding it backwards.

Take off the back cover by pushing it down and sliding it backwards.

Edit

Step 2

Take out the battery, SIM card, and MicroSD card.

Take out the battery, SIM card, and MicroSD card.
Unscrew the two T6 Torx screws.

Edit

Step 3

Try to seperate the front cover from the rest of the phone. The front cover is held by four plastic clips.

Try to seperate the front cover from the rest of the phone. The front cover is held by four plastic clips.
The first time you do this you may have to use some force but do it in a controlled way. If you break the plastic clips you'll need a new front cover.

Edit

Step 4

You can take off the keypad now, this is sitting loose on top of the sensors.

You can take off the keypad now, this is sitting loose on top of the sensors.
Unscrew the four remaining T6 Torx screws.
The screws holding the motherboard in place are different from the two previous screws which held the rear cover in place.

Edit

Step 5

The motherboard with it's screen are now loose, you can pop it right out.

The motherboard with it's screen are now loose, you can pop it right out.
If you've been using this phone for a while, there's probably some dust inside the back shell.
There's a lot of contacts exposed, so make sure not to damage those.