Introduction

This guide will allow you how to access the internal components of the device.

Parts

No parts required.

Flip the device to the backside, and locate the metal tab at the center of the back cover.
  • Flip the device to the backside, and locate the metal tab at the center of the back cover.

Add Comment

Lift the metal tab up, and rotate it counterclockwise. This will unlock the back case cover.
  • Lift the metal tab up, and rotate it counterclockwise. This will unlock the back case cover.

Add Comment

Lift the battery plate off to either insert or remove 2 AA batteries. Lift the battery plate off to either insert or remove 2 AA batteries.
  • Lift the battery plate off to either insert or remove 2 AA batteries.

Add Comment

With the wedge side of a spudger (or a small, flat head screwdriver), remove the black rubber case support from the device body. With the wedge side of a spudger (or a small, flat head screwdriver), remove the black rubber case support from the device body.
  • With the wedge side of a spudger (or a small, flat head screwdriver), remove the black rubber case support from the device body.

Add Comment

With the pick side of a spudger (or tweezers), peel the sticky tape from the device. With the pick side of a spudger (or tweezers), peel the sticky tape from the device. With the pick side of a spudger (or tweezers), peel the sticky tape from the device.
  • With the pick side of a spudger (or tweezers), peel the sticky tape from the device.

Add Comment

Split the front and rear panels by inserting a small pointed tool (such as a pen point or a screwdriver tip SL1.5) in the 5 plastic tabs along the sides of the device.
  • Split the front and rear panels by inserting a small pointed tool (such as a pen point or a screwdriver tip SL1.5) in the 5 plastic tabs along the sides of the device.

  • Do not remove the back panels quickly. If too much force is applied, there is a wire connection that will break.

  • CAUTION! Be careful not to force the tabs inward. This will result in broken tabs.

Add Comment

With tweezers (or your fingernails), carefully disconnect the wires between the PC input and the motherboard. With tweezers (or your fingernails), carefully disconnect the wires between the PC input and the motherboard.
  • With tweezers (or your fingernails), carefully disconnect the wires between the PC input and the motherboard.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

5 other people completed this guide.

Ryan Green

Member since: 10/17/2010

69 Reputation

1 Guide authored

Team

Cal Poly, Team 21-30, Regan Fall 2010 Member of Cal Poly, Team 21-30, Regan Fall 2010

CPSU-REGAN-F10S21G30

3 Members

5 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 1

Past 7 Days: 11

Past 30 Days: 28

All Time: 3,912