Disassembling Wii Balance Board

You're viewing a previously published version of this guide. View latest version

Aug 14, 2013 - 05:41:33

Aug 14, 2013 - 05:41:33 Sep 14, 2011 - 01:23:26 Sep 14, 2011 - 01:22:34 Sep 14, 2011 - 01:21:25 Sep 14, 2011 - 01:21:17 Sep 14, 2011 - 01:15:56 Sep 14, 2011 - 01:15:54 Sep 14, 2011 - 01:08:40 Sep 14, 2011 - 01:08:37 Sep 14, 2011 - 01:04:48 Sep 14, 2011 - 01:04:46 Sep 14, 2011 - 01:01:12 Sep 14, 2011 - 01:01:10 Sep 14, 2011 - 01:00:45 Sep 14, 2011 - 01:00:43 Sep 14, 2011 - 01:00:08 Sep 14, 2011 - 12:58:04 Sep 14, 2011 - 12:58:02 Sep 14, 2011 - 12:58:01 Sep 14, 2011 - 12:36:17

Newer

What you need

Step 1 Floor Unit

Disassembling Wii Balance Board, Floor Unit: step 1, image 1 of 1

Unscrew these #1 Philips screws, and leave them in the plastic foot holders.

Step 2

Remove the foot holders and place them on the side

Step 3

Remove the four feet and place them on the side

Step 4

Remove these #1 Philips screws, and leave them in their counterbores

Step 5

Lift grey shell off and place to the side to reveal:
ADC and Logic board
Bluetooth module
Strain gauges
Battery holder

Step 6

The ADC and Logic board contains:
Bluetooth module
Power button connector
Battery and sync button connector
Strain gauge wheatstone bridge connections
The topmost connection for each of the four bridge connections is the ground; relative to this, the two middle connections should be at 1.2 VDC, and the bottom should be at 2.7 VDC