Parts

No parts required.

Unscrew these #1 Philips screws, and leave them in the plastic foot holders.
  • Unscrew these #1 Philips screws, and leave them in the plastic foot holders.

Add Comment

Remove the foot holders and place them on the side
  • Remove the foot holders and place them on the side

Add Comment

Remove the four feet and place them on the side
  • Remove the four feet and place them on the side

Add Comment

Remove these #1 Philips screws, and leave them in their counterbores
  • Remove these #1 Philips screws, and leave them in their counterbores

Add Comment

Lift grey shell off and place to the side to reveal:
  • Lift grey shell off and place to the side to reveal:

  • ADC and Logic board

  • Bluetooth module

  • Strain gauges

  • Battery holder

Add Comment

The ADC and Logic board contains:
  • The ADC and Logic board contains:

  • Bluetooth module

  • Power button connector

  • Battery and sync button connector

  • Strain gauge wheatstone bridge connections

    • The topmost connection for each of the four bridge connections is the ground; relative to this, the two middle connections should be at 1.2 VDC, and the bottom should be at 2.7 VDC

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

10 other people completed this guide.

Pete Marchetto

Member since: 01/25/2011

421 Reputation

1 Guide authored

One Comment

Great stuff Pete, being able to fix the wifi board got me mucho street cred with " her indoors " and lots of other goodies that go along with that

HENRY - Reply

Add Comment

View Statistics:

Past 24 Hours: 3

Past 7 Days: 12

Past 30 Days: 77

All Time: 7,071