Introduction

This guide will explain how to take off the camera's exterior case.

Parts

No parts required.

Image 1/1: All screws are the same size and length and can be used interchangably.
  • Begin by placing the camera upside down and removing the three small center screws.

  • All screws are the same size and length and can be used interchangably.

Add Comment

Image 1/2: Turn the camera 180 degrees onto its other side and remove the two small screws on either side of the silver panel. Image 2/2: Turn the camera 180 degrees onto its other side and remove the two small screws on either side of the silver panel.
  • Turn the camera on its side (Counterclockwise). Remove the two small screws on either side of the silver panel.

  • Turn the camera 180 degrees onto its other side and remove the two small screws on either side of the silver panel.

Add Comment

Image 1/3: Carefully remove the camera's tripod mount and place it aside. Image 2/3: Be careful not to lose this piece. Image 3/3: Rotate the silver panel labeled 4x clockwise.
  • Locate the camera's tripod mount located on the bottom of the camera.

  • Carefully remove the camera's tripod mount and place it aside.

  • Be careful not to lose this piece.

  • Rotate the silver panel labeled 4x clockwise.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

4 other people completed this guide.

Alex

Member since: 03/09/2012

172 Reputation

3 Guides authored

Team

Clemson, Team 2-3, Benson Spring 2012 Member of Clemson, Team 2-3, Benson Spring 2012

CLEM-BENSON-S12S2G3

3 Members

6 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 1

All Time: 1,242