Introduction

How to disassemble Axis 214 PTZ camera.

  1. 4 screws 4 screws
    • 4 screws

  2. 7 screws 7 screws 7 screws
    • 7 screws

  3. Remove (4) Phillips screws. Carefully disconnect the ribbon connector. Odklopi konektor.
    • Remove (4) Phillips screws.

    • Carefully disconnect the ribbon connector.

    • Odklopi konektor.

  4. Remove (4) Phillips screws. 4 screws, težko odšraufati If replacing the logic board, remove (2) cables at the connectors. Odključi priključke (označi kateri je kateri ! At the underside of the logic board, disconnect the connector.  Izključi konektor (na kontektorju so spredaj številke)
    • Remove (4) Phillips screws. 4 screws, težko odšraufati

    • If replacing the logic board, remove (2) cables at the connectors. Odključi priključke (označi kateri je kateri !

    • At the underside of the logic board, disconnect the connector. Izključi konektor (na kontektorju so spredaj številke)

  5. Free shipping on all orders over $100 or containing a Pro Tech Toolkit!

    Browse Our Store
  6. Gently press back the plastic clip at both sides. Izključi plastični zatič na obeh straneh Remove 2 screws.  2 šraufa. Remove (3) Phillip screws. 3 šraufi (2+1)
    • Gently press back the plastic clip at both sides. Izključi plastični zatič na obeh straneh

    • Remove 2 screws. 2 šraufa.

    • Remove (3) Phillip screws. 3 šraufi (2+1)

  7. Remove (4) Phillips screws.  4x vijak. Carefully disconnect ribbon and flex cables. 2x flat in odstraniš glavo iz kletke (v bistvu asmo 1 flat!
    • Remove (4) Phillips screws. 4x vijak.

    • Carefully disconnect ribbon and flex cables. 2x flat in odstraniš glavo iz kletke (v bistvu asmo 1 flat!

  8. Remove (2) Phillip screws.  2 šraufa(samo odtegneš, pustiš notri).
    • Remove (2) Phillip screws. 2 šraufa(samo odtegneš, pustiš notri).

    • Remove (1) protective clip. 1 varovalna sponka.

  9. Remove 2 screws one on each side. 2 šraufa Turn the latch mechanism to the right. obrni zatič na desno.
    • Remove 2 screws one on each side. 2 šraufa

    • Turn the latch mechanism to the right. obrni zatič na desno.

  10. It is difficult to disassemble. Težko za razstaviti Težko za razstaviti
    • It is difficult to disassemble.

    • Težko za razstaviti

  11. Remove (4) recessed screws. 4 šraufi, odstraniš plastiko, pazi na flat kabel. Disconnect flat Ribbon Cable. Flat kabel.
    • Remove (4) recessed screws. 4 šraufi, odstraniš plastiko, pazi na flat kabel.

    • Disconnect flat Ribbon Cable. Flat kabel.

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 other people completed this guide.

lukahlastec

Member since: 06/02/2011

156 Reputation

1 Guide authored

0 Comments

View Statistics:

Past 24 Hours: 0

Past 7 Days: 2

Past 30 Days: 10

All Time: 1,142