Introduction

Before replacing any components on the Arnova 7K G3 tablet, disassembly is required. That process starts with removing the rear cover to gain access to a majority of the components including the battery, speaker, and logic board.

Image 1/3: Remove the screws using the Philips #00 screwdriver. Image 2/3: Remove the screws using the Philips #00 screwdriver. Image 3/3: Remove the screws using the Philips #00 screwdriver.
  • Locate the four 5mm Phillips head screws, one at each corner of the tablet.

  • Remove the screws using the Philips #00 screwdriver.

Add Comment

Image 1/2: For that, locate the notches between the two cases. Image 2/2: Place the tool in the notches and  start separating the two covers apart.
  • Next step is to pull apart the front and rear cover using the IFixit Plastic Opening Tool.

  • For that, locate the notches between the two cases.

  • Place the tool in the notches and start separating the two covers apart.

Add Comment

Image 1/1: Proceed to remove the rear cover by gently pulling it apart by hand.
  • Repeat step two until 3/4th of the rear cover is unlatched.

  • Proceed to remove the rear cover by gently pulling it apart by hand.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Tyler Sigafoose

Member since: 03/19/2015

210 Reputation

2 Guides authored

Team

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 2

All Time: 142