Introduction

The logic board is an essential part of an electronic device. Removing the board is a significant step while accessing or removing some components of the device. This guide shows you how to accomplish this task.

Locate the four 5mm Phillips head screws, one at each corner of the tablet. Remove the screws using the Philips #00 screwdriver. Remove the screws using the Philips #00 screwdriver.
  • Locate the four 5mm Phillips head screws, one at each corner of the tablet.

  • Remove the screws using the Philips #00 screwdriver.

Add Comment

Next step is to pull apart the front and rear cover using the IFixit Plastic Opening Tool. For that, locate the notches between the two cases.
  • Next step is to pull apart the front and rear cover using the IFixit Plastic Opening Tool.

  • For that, locate the notches between the two cases.

  • Place the tool in the notches and start separating the two covers apart.

Add Comment

Repeat step two until 3/4th of the rear cover is unlatched.
  • Repeat step two until 3/4th of the rear cover is unlatched.

  • Proceed to remove the rear cover by gently pulling it apart by hand.

Add Comment

Deck the Halls
With tools and Fix Kits
Locate the copper tape covering the ribbon connector one. Peel it with a set of tweezers. Locate the copper tape covering the ribbon connector one. Peel it with a set of tweezers.
  • Locate the copper tape covering the ribbon connector one. Peel it with a set of tweezers.

Add Comment

Locate the two gray pins on the ribbon connector. Grab the first pin with tweezers and gently pull it towards the ribbon. Repeat the step. Gently pull the ribbon cable out of the connection port.
  • Locate the two gray pins on the ribbon connector.

  • Grab the first pin with tweezers and gently pull it towards the ribbon. Repeat the step.

  • Gently pull the ribbon cable out of the connection port.

Add Comment

Locate the ribbon connector two. Locate the pins of ribbon connector two. Repeat step two for unlocking the pins. Gently pull the ribbon out of the connection port.
  • Locate the ribbon connector two.

  • Locate the pins of ribbon connector two. Repeat step two for unlocking the pins.

  • Gently pull the ribbon out of the connection port.

Add Comment

Locate the two Phillips head screws attaching the logic board to the tablet structure.
  • Locate the two Phillips head screws attaching the logic board to the tablet structure.

  • Remove the screws using the #00 Philip's head screwdriver.

Add Comment

Gently lift up the logic board and reorient it in a more efficient manner in order to locate the desired components.
  • Gently lift up the logic board and reorient it in a more efficient manner in order to locate the desired components.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Kue

Member since: 03/18/2015

301 Reputation

3 Guides authored

Team

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 2

All Time: 248