DigiTech RP70 DC Power Connector Replacement

Step 1 Motherboard



• Unplug the device from its AC power adapter; unplug anything connected to the input/output jacks.
• Remove the four 8mm Phillips #0 screws located on the back panel.
Edit
Add a comment
Add a comment
Add Comment
1024
Cancel Post comment
Step 2



• Remove the back panel to expose the motherboard.
Edit
Add a comment
Add a comment
Add Comment
1024
Cancel Post comment
Step 3
• Remove the two 11mm #0 Phillips screws located at the bottom of the motherboard.
Edit
Add a comment
Add a comment
Add Comment
1024
Cancel Post comment
Step 4
• Lift the indented end of the motherboard opposite the input/output jacks. Then, pull away from the input/output jacks to slide the motherboard out of the casing.
Edit
Add a comment
Add a comment
Add Comment
1024
Cancel Post comment
Step 5 DC Power Connector
• Desolder the back of the motherboard where the power connector is located.
Edit
Add a comment
Add a comment
Add Comment
1024
Cancel Post comment

Author

with 4 other contributors

Elijah Smith

Member since: 09/10/18

738 Reputation

6 Guides authored

Badges: 10

• 
• 
• 

+7 more badges

Team

Appalachian State University, Team S2-G2, Menagarishvili Fall 2018 Member of Appalachian State University, Team S2-G2, Menagarishvili Fall 2018

APSU-MENAGARISHVILI-F18S2G2

3 Members

6 Guides authored

Embed this guide

Choose a size and copy the code below to embed this guide as a small widget on your site / forum.

Preview