Introduction

Use this guide to replace the entire Dell Latitude e6410 screen assembly. You will be removing the entire old screen assembly and replacing it with the new screen.

Use this guide only to replace the entire screen assembly. "Screen assembly" refers to the all of the screen components fully assembled into the screen case including the display, camera, and other components.

Parts

No parts required.

Slide both clips in towards each other to remove the battery from the laptop. It is always important to remove an electronic device's power source when taking it apart to prevent electrocution. It is always important to remove an electronic device's power source when taking it apart to prevent electrocution.
  • Slide both clips in towards each other to remove the battery from the laptop.

  • It is always important to remove an electronic device's power source when taking it apart to prevent electrocution.

Add Comment

Remove the two 5 mm Phillip's screws located on the left and right side of the battery socket.
  • Remove the two 5 mm Phillip's screws located on the left and right side of the battery socket.

Add Comment

Remove the two gray squares by sliding each piece towards you. Remove the two gray squares by sliding each piece towards you. Remove the two gray squares by sliding each piece towards you.
  • Remove the two gray squares by sliding each piece towards you.

Add Comment

Remove the two 5mm Phillip's screws in the bottom right and the top left corners of the back panel. Remove the 3mm Phillip's screw that is near the bottom right corner. Loosen the Phillip's screw that is near the center until the spring pops up, but do not remove it.
  • Remove the two 5mm Phillip's screws in the bottom right and the top left corners of the back panel.

  • Remove the 3mm Phillip's screw that is near the bottom right corner.

  • Loosen the Phillip's screw that is near the center until the spring pops up, but do not remove it.

  • Detach the back case panel by sliding it away from the battery slot and lifting it out of place.

  • When reattaching the back panel slide it towards the location of the battery instead of away from it while also applying pressure downwards.

Add Comment

Mac RAM Kits
Speed up your Mac. Max out its memory.
Mac RAM Kits
Get more memory out of your Mac.
Loosen the two 5mm Phillip's screws near the top right corner that are holding the display cable onto the motherboard. Loosen the two 5mm Phillip's screws near the top right corner that are holding the display cable onto the motherboard.
  • Loosen the two 5mm Phillip's screws near the top right corner that are holding the display cable onto the motherboard.

Add Comment

Detach the display cord from the motherboard by grabbing the blue tab in between your thumb and index finger and carefully pulling upwards. Don't pull too hard or you may rip off the tab, but apply enough pressure so that it actually comes off. Don't pull too hard or you may rip off the tab, but apply enough pressure so that it actually comes off.
  • Detach the display cord from the motherboard by grabbing the blue tab in between your thumb and index finger and carefully pulling upwards.

  • Don't pull too hard or you may rip off the tab, but apply enough pressure so that it actually comes off.

Add Comment

Near the bottom left corner, detach the grey, black, and white wires from the graphics card and the two wires hooked in place by carefully unhooking them or pulling them off. When reassembling use the second or last picture to reference where each wire goes. When reassembling use the second or last picture to reference where each wire goes.
  • Near the bottom left corner, detach the grey, black, and white wires from the graphics card and the two wires hooked in place by carefully unhooking them or pulling them off.

  • When reassembling use the second or last picture to reference where each wire goes.

Add Comment

Carefully unthread the wires detached in the last step from the hooks to completely free them from the laptop.
  • Carefully unthread the wires detached in the last step from the hooks to completely free them from the laptop.

Add Comment

Remove the two 5mm Phillip's screws that are in the top right and left corners of the laptop.
  • Remove the two 5mm Phillip's screws that are in the top right and left corners of the laptop.

Add Comment

Flip the laptop so that the top is facing up and grab the back two corners of the laptop screen. Pull upwards to remove the screen. When reassembling use the new laptop screen. When reassembling use the new laptop screen.
  • Flip the laptop so that the top is facing up and grab the back two corners of the laptop screen. Pull upwards to remove the screen.

  • When reassembling use the new laptop screen.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

6 other people completed this guide.

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 5

Past 7 Days: 14

Past 30 Days: 63

All Time: 1,216