Dell Inspiron 14z-5423 Keyboard Replacement

Step 1 RAM



• Close the display and turn over the computer.
• Make sure your device is powered down and unplugged before beginning the replacement.
Step 2

• Use a J0 bit tipped screwdriver to unscrew the one 6 mm Phillips screw on the RAM cover.
Step 3
• Lightly lift the RAM cover up and at an angle, away from the computer.
Step 4
• Use your fingers to carefully pull the securing clips on the RAM away from each other.
• The RAM should pop up when the clips are released.
Step 5
• Remove the popped up RAM by pulling it away from the connection.
• If it does not pop up pry it out in a steady and straight direction.
Step 6 Keyboard
• Lift the plastic yellow flap on the system board.
• Use the J0 Bit screwdriver to remove the one 6 mm Phillips screw in center of the system board that is connected to the keyboard.
Step 7
• Flip over the computer and open the display.
Step 8
• Insert a spudger next to the plastic indents located at the top of the keyboard and gently pry to release the securing clips.
• Lift the keyboard off of the computer.
• Be careful not to tear the ribbon that attaches the back of the keyboard to the computer when lifting it.
Step 9
• Flip the keyboard over onto the palm-rest assembly.
Step 10
• Flip the little black securing bar near the base of the ribbon with a spudger to release the ribbon from the computer.

Author

with 6 other contributors

Marisol

Member since: 09/12/16

623 Reputation

4 Guides authored

Badges: 14

• 
• 
• 

+11 more badges

Team

CSU Fullerton, Team 2-2, Bruce Fall 2016 Member of CSU Fullerton, Team 2-2, Bruce Fall 2016

CSUF-BRUCE-F16S2G2

5 Members

11 Guides authored

Embed this guide

Choose a size and copy the code below to embed this guide as a small widget on your site / forum.

Preview