Introduction
It is advised to proceed with caution when carrying out this procedure. Damage to the sensitive electronic components may occur.
What you need
-
-
Remove the (10) P58F black screws on the back cover using the Phillips #0 screwdriver.
-
After removing the screws, remove the back cover using a plastic or metal spudger.
-
-
-
-
Unscrew the 3.7mm screw that attaches the solid state drive with the Phillips #0 screwdriver.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
2 other people completed this guide.
Team
IUPUI, Team S2-G1, Harley Spring 2019 Member of IUPUI, Team S2-G1, Harley Spring 2019
IUPUI-HARLEY-S19S2G1
3 Members
2 Guides authored
