Introduction

This guide will show you the necessary steps to replace the saw blade. The blade is not included in these pictures.

Take out the Allen Key that is located on the front of the saw below the smooth control handle on the top of the saw.
  • Take out the Allen Key that is located on the front of the saw below the smooth control handle on the top of the saw.

Add Comment

Use the Allen Key to replace to loosen the bolt where the center of the saw is/would be.
  • Use the Allen Key to replace to loosen the bolt where the center of the saw is/would be.

Add Comment

Black Friday
Broken doesn't stand a chance.
Remove the circular nut that is used to hold the saw blade in place. It slide right off.
  • Remove the circular nut that is used to hold the saw blade in place. It slide right off.

Add Comment

Lift up the plastic cover on the bottom to expose the bottom slot on the saw.
  • Lift up the plastic cover on the bottom to expose the bottom slot on the saw.

Add Comment

Place blade on the peg in the middle of the saw. The peg has two flat sides as does the saw hole to prevent slipping when spinning.
  • Place blade on the peg in the middle of the saw. The peg has two flat sides as does the saw hole to prevent slipping when spinning.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Scott Weinhardt

Member since: 01/25/2017

501 Reputation

5 Guides authored

Team

Cal Poly, Team 8-2, Banghart Winter 2017 Member of Cal Poly, Team 8-2, Banghart Winter 2017

CPSU-BANGHART-W17S8G2

3 Members

5 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 5

Past 30 Days: 20

All Time: 253