Introduction

The table guard is essential in making sure the Craftsman Model 315.10721 makes the desired cuts. Keep in mind when performing the replacement that disassembling the table guard is time consuming.

  1. Using a flathead screwdriver, remove the 1/2" flathead screw to allow the table guard to pivot.
    • Using a flathead screwdriver, remove the 1/2" flathead screw to allow the table guard to pivot.

  2. Pivot the table guard from its upright position to an angle.
    • Pivot the table guard from its upright position to an angle.

    • Using a Phillips #1 screwdriver, remove the 1" Phillips screw and the nut on the opposite side.

  3. Free shipping on all orders over $100 or containing a Pro Tech Toolkit!

    Browse Our Store
  4. Using the Phillips #1 screwdriver, remove eight 1" Philips screws from the main case.
    • Using the Phillips #1 screwdriver, remove eight 1" Philips screws from the main case.

    • Carefully remove the main case to expose the inside of the saw.

  5. Remove the old table guard by gently lifting it away from the main case.
    • Remove the old table guard by gently lifting it away from the main case.

    • Replace the old table guard with the new one by placing it in the same orientation as the one removed.

Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Riley Hilliker

Member since: 10/14/2014

561 Reputation

5 Guides authored

Team

Cal Poly, Team 4-47, Amido Fall 2014 Member of Cal Poly, Team 4-47, Amido Fall 2014

CPSU-AMIDO-F14S4G47

4 Members

5 Guides authored

0 Comments

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 2

All Time: 303