Introduction

If you are having trouble adjusting the headband on your Skullcandy Mix Master DJ headphones, you may need to simply clean the slider tracks to remove any obstructions. This guide will show you how to that in just four few easy steps.

Parts

No parts required.

Remove the Skullcandy Mix Master DJ Headphones from any casing or protective gear.
  • Remove the Skullcandy Mix Master DJ Headphones from any casing or protective gear.

Add Comment

Rotate the headphones so that one of the speaker cups are facing you. Remove the four Phillips 3 mm screws along the headband cover.
  • Rotate the headphones so that one of the speaker cups are facing you. Remove the four Phillips 3 mm screws along the headband cover.

Add Comment

Black Friday
Broken doesn't stand a chance.
Gently remove the cover from the headband.
  • Gently remove the cover from the headband.

  • Removing the cover too fast could break the thin wire within the headband.

Add Comment

Using a moist Q-tip or small towel, carefully wipe the inside of the headband sheath.
  • Using a moist Q-tip or small towel, carefully wipe the inside of the headband sheath.

  • Be careful when cleaning to avoid damaging to the wire.

  • Do not use cleaning solvents. They may cause the plastic to break down.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Seth Blackburn

Member since: 03/30/2015

110 Reputation

1 Guide authored

Team

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 2

Past 30 Days: 7

All Time: 237