Introduction

If you need to replace your LCD Screen on your Canon PowerShot SX260 HS this guide is for you!

Be sure to always remove the battery from the camera before disassembling to avoid permanent damage. The camera has a total of 6 (3 mm) external screws that will need to be removed; 2 on the left side, 2 on the bottom, and 2 on the right side. Remove the 2 (3 mm) screws on the left side
  • Be sure to always remove the battery from the camera before disassembling to avoid permanent damage.

  • The camera has a total of 6 (3 mm) external screws that will need to be removed; 2 on the left side, 2 on the bottom, and 2 on the right side.

  • Remove the 2 (3 mm) screws on the left side

  • Remove the 2 (3 mm) screws on the bottom of the camera.

  • Remove the 2 (3 mm) screws on the right side of the camera.

Add Comment

Use your plastic opening tool to gently lift and remove back face plate.
  • Use your plastic opening tool to gently lift and remove back face plate.

Add Comment

After removing exterior screws, gently lift off the front face plate with your fingers.
  • After removing exterior screws, gently lift off the front face plate with your fingers.

Add Comment

Black Friday
Broken doesn't stand a chance.
Remove the 4 (3 mm) screws that are under the face plate.
  • Remove the 4 (3 mm) screws that are under the face plate.

Add Comment

Next, remove the 2 (3 mm) interior screws on the left side of the camera.
  • Next, remove the 2 (3 mm) interior screws on the left side of the camera.

Add Comment

After removing the interior left screws, use a plastic opening tool to gently pull the top face plate off.
  • After removing the interior left screws, use a plastic opening tool to gently pull the top face plate off.

Add Comment

Next,take off the 2 (3mm) screws on the back side of the camera to remove the dial panel.
  • Next,take off the 2 (3mm) screws on the back side of the camera to remove the dial panel.

  • Gently lift the panel with your fingers.

  • Be careful not to rip the attached yellow ribbon cable.

Add Comment

Carefully unplug the yellow ribbon cable from the front of the camera using your tweezers.
  • Carefully unplug the yellow ribbon cable from the front of the camera using your tweezers.

Add Comment

Gently slide the LCD screen to the right and remove.
  • Gently slide the LCD screen to the right and remove.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Tyler Kelch

Member since: 03/05/2015

541 Reputation

4 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 4

Past 7 Days: 23

Past 30 Days: 106

All Time: 1,781