Canon PowerShot A590 IS Back Cover Replacement

Step 1 Batteries



• The battery hatch is on the bottom of the camera.
• CAUTION: Locate the switch to open the hatch and push gently toward the front of the camera. Too much force can break the hatch.
• While the switch is pushed forward, pull the cover away from the camera.
Step 2

• This camera requires AA batteries.
• To remove batteries, simply allow them to fall out of the camera.
• Use a fingernail to lift the clock battery out of the camera.
Step 3
• When replacing the AA batteries, verify they are oriented correctly by following the (+) and (-) signs on the camera.
Step 4 Remove Screw Near AV Port
• Remove the screw located under the rubber flap on the left side of the camera using a magnetic screwdriver.
Step 5 Remove Side Screws
• Remove the two screws located on the other side of the camera using a magnetic screwdriver
Step 6 Remove Bottom Screws
• Remove the three screws located at the bottom of the camera using a magnetic screwdriver.
Step 7 Remove Back Cover
• Open the battery cover.
• Using the iPod tool, push up gently around all edges of the camera.

Author

with 9 other contributors

Zach

Member since: 10/11/10

281 Reputation

6 Guides authored

Badges: 12

• 
• 
• 

+9 more badges

Team

Cal Poly, Team 9-19, Regan Fall 2010 Member of Cal Poly, Team 9-19, Regan Fall 2010

CPSU-REGAN-F10S9G19

4 Members

14 Guides authored

Embed this guide

Choose a size and copy the code below to embed this guide as a small widget on your site / forum.

Preview