Canon PowerShot A3400 IS Plastic Case Replacement

Step 1 Battery

• Place thumb on area right next to where it says open and slide to the right to open.
Step 2

• Remove the battery by pushing the orange object outwards; the battery will spring up and out.
Step 3 Plastic Case
• Remove the two 5.00 mm screws in the bottom of the casing with a Philips #000 screwdriver
Step 4
• Place the camera on to the side that has the image stabilizer label.
• Remove the 5.00 mm screws that are on this side using the screwdriver.
Step 5
• Place camera on to the side with the A/V Out Digital Cover facing up.
• Remove this visible 5.00 mm screw.
• Pull the A/V Out Digital cover back to uncover the next step.
Step 6
• Remove the 5.00 mm screw from behind the cover.
Step 7
• Make sure the battery cover is open.
Step 8
• Turn the camera onto the side with the A/V out Digital cover.
• Use your finger to pull this tab to the right.
Step 9
• Remove the lens side by using your fingers or a spudger to pry it gently open.
• Try to pry it loose all around that side so that it is easier to pull off.
Step 10
• Using your fingers, pull the screen side gently off.
• Try to loosen it all around that side so that it is easier to try and pull it off.

Author

with 2 other contributors

Emily Pretorius

Member since: 01/13/15

325 Reputation

3 Guides authored

Badges: 10

• 
• 
• 

+7 more badges

Team

USF Tampa, Team 1-1, Sullivan Winter 2015 Member of USF Tampa, Team 1-1, Sullivan Winter 2015

USFT-SULLIVAN-W15S1G1

3 Members

8 Guides authored

Embed this guide

Choose a size and copy the code below to embed this guide as a small widget on your site / forum.

Preview