Introduction

Take out old, dead, batteries. Then replace them with new ones.

Image 1/2: Gently push on the outer batter case to pop it open. Image 2/2: It should now look like this.
  • Tilt the camera until this side is facing up.

  • Gently push on the outer batter case to pop it open.

  • It should now look like this.

Add Comment

Image 1/2: Push down on the latch, and pop it open. Image 2/2: The batteries should now be easily accessible to remove.
  • You will now see a second battery cover.

  • Push down on the latch, and pop it open.

  • The batteries should now be easily accessible to remove.

Add Comment

Image 1/1: Now push the inner cover down to secure the batteries in place.
  • After removing the batteries, insert new batteries. (make sure they are facing the correct direction)

  • Now push the inner cover down to secure the batteries in place.

  • Push down and forward on the outer cover to secure the latch. Your camera will now be fully charged.

Add Comment

Conclusion

Congratulations, you're done.

Ellen Chambers

Member since: 01/05/2011

231 Reputation

2 Guides authored

Team

Cal Poly, Team 7-37, Regan Winter 2011 Member of Cal Poly, Team 7-37, Regan Winter 2011

CPSU-REGAN-W11S7G37

4 Members

3 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 2

All Time: 1,546