Skip to main content

You're viewing a previously published version of this guide.  View latest version

Older Newer

Introduction

The grips for the 60D come off easy, they just peel off. For many 60D owners, Canon already helped you by choosing a poor / defective adhesive for the first few batches of cameras shipped.

Parts

No parts specified.

  1. Use a thin piece of plastic, spudger, or fingernail (if you have them) to lift up the edge of the grip, and pull up slowly.
    • Use a thin piece of plastic, spudger, or fingernail (if you have them) to lift up the edge of the grip, and pull up slowly.

    • Repeat for the other two grips

    • The large one on the battery-side is the easiest to start with. This is required to remove the front & back panels

    • The small one on the back is a bit difficult to get started, but not really difficult to remove.

    • The one on the AV panel will be easier if you open up the AV port cover.

    • Remove the adhesive like you would rubber cement, just rub your finger against it, it will come off.

    • Optionally throw the balled up adhesive at people pretending its a booger :)

Eric D

Member since: 11/13/2012

1,116 Reputation

5 Guides authored

View Statistics:

Past 24 Hours: 1

Past 7 Days: 7

Past 30 Days: 30

All Time: 10,523