Introduction

The eye piece will be easily accessible to replace after removing the top panel of the camera.

Parts

No parts required.

Open up the battery door.
  • Open up the battery door.

Add Comment

Remove the batteries from the camera by sliding them out into your palm.
  • Remove the batteries from the camera by sliding them out into your palm.

Add Comment

  • Release the side latch to open the back panel.

Add Comment

  • Remove the two black 4.5mm screws above and below the latch.

Add Comment

  • Using your finger, carefully pry open the side panel from the top of camera.

  • Pull panel downwards to remove.

  • Make sure to keep track of the small black piece of rubber under the latch.

Add Comment

  • Remove the two silver 6mm Phillips #1 screws.

Add Comment

  • Flip camera over to the bottom.

  • Remove the one 5mm Phillips #1 silver screw.

Add Comment

  • Remove the front panel by pulling away from the side with the lever.

Add Comment

  • Remove three black 7.3mm Phillips #1 screws located on the corners of the camera.

  • Remove five black 4.8mm Phillips #1 screws.

Add Comment

  • Simply remove the bottom panel by prying it off with your finger.

  • When removing the panel, be sure the bottom of the camera is facing upright. There are loose gears that may fall out.

  • Be wary of a loose piece of foam attached to the bottom panel.

Add Comment

  • Remove the remote control socket cover.

Add Comment

  • Remove two black 4.5mm Phillips #1 screws.

Add Comment

  • Remove two black 4.8mm Phillips #1 screws on the front of the camera.

Add Comment

  • Pry open the side grip using a spudger.

Add Comment

  • With your hands, remove the rubber grip from the eye piece.

Add Comment

  • Remove the eyecup from the eyepiece by pushing the eyecup up.

Add Comment

  • Remove two silver 5.0mm Phillips #1 screws.

Add Comment

  • Remove the silver 5.5mm Phillips #1 screw.

Add Comment

  • Pry the top silver part of the camera off.

  • Buttons may slip out of the camera's top as the top is pulled off the camera (shown in picture two).

Add Comment

  • Remove the two black 9.5mm screws.

Add Comment

  • Remove two black 8.8mm Phillips #1 screws with a screw driver.

  • Remove the right screw first (the one without the tape).

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Tammy Kong

Member since: 01/23/2014

643 Reputation

6 Guides authored

Team

Cal Poly, Team 6-20, Maness Winter 2014 Member of Cal Poly, Team 6-20, Maness Winter 2014

CPSU-MANESS-W14S6G20

4 Members

11 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 6

All Time: 287