Brother PT-110 Keypad Contacts Replacement

Step 1 Batteries



• Push on the side of the cover, and remove it.
Step 2

• Remove the batteries.
Step 3 Back Plate
• Unscrew the two 9 mm Phillips #1 screws from the top and bottom.
• Total: 2 x Screws
Step 4
• First: To separate the top cover from the body, insert a spudger between the two halves.
• Gently twist the spudger until the two halves separate. Do this in multiple spots around the perimeter of the cover to distribute the pressure.
• DO NOT PULL HALVES APART. There are wired connections inside that must be disconnected before halves can be fully separated.
Step 5
• Gently separate the two covers, ensuring wires are not taut.
Step 6
• Gently grasp the ribbon wire and top cover, then gently pull the ribbon wire out of its connection.
Step 7
• Carefully pinch the top of the connector.
• Pull perpendicular to the device until the wire is disconnected.
• It may require more force than expected to disconnect the wires.
Step 8
• Unscrew the three 9 mm Phillips #1 screws shown.
• Total: 3 x Screws
Step 9 Keypad Contacts
• Unscrew both 6 mm Phillips #1 screws from the circuit board.
• Total screws: 2
Step 10
• Gently lift the circuit board out.
Step 11
• Peel the keypad contacts up from the plastic casing.

Author

with 3 other contributors

Kimberly Larsen

Member since: 09/28/16

237 Reputation

5 Guides authored

Badges: 11

• 
• 
• 

+8 more badges

Team

IUPUI, Team 1-1, Harley Fall 2016 Member of IUPUI, Team 1-1, Harley Fall 2016

IUPUI-HARLEY-F16S1G1

3 Members

7 Guides authored

Embed this guide

Choose a size and copy the code below to embed this guide as a small widget on your site / forum.

Preview