Fix Your Stuff Community Store

Brentwood TS-292B Heating Wire Replacement

Introduction

This guide will show how to remove and replace the nichrome wire (heating wire) of the Brentwood TS-292B.

What you need

  1. Brentwood TS-292B Heating Wire Replacement, Heating Wire: step 1, image 1 of 2 Brentwood TS-292B Heating Wire Replacement, Heating Wire: step 1, image 2 of 2

    • Remove the five screws to loosen the the outer housing from the internal components.

    • Pull up on the black plastic housing until it is dislodged from the base.

    Edit

  2. Brentwood TS-292B Heating Wire Replacement: step 2, image 1 of 3 Brentwood TS-292B Heating Wire Replacement: step 2, image 2 of 3 Brentwood TS-292B Heating Wire Replacement: step 2, image 3 of 3

    • You will need to remove the toasting lever by removing the black tab from the lever.

    • You will now be able to completely remove the housing from the base of the toaster.

    Edit

    • You will need small chain nose pliers to check for slack on either end of the broken wire.

    • If there is no slack in the wire, you must buy extra nichrome wire in order to fix your toaster.

    Edit

  5. Brentwood TS-292B Heating Wire Replacement: step 4, image 1 of 1

    • Pull the slack out of the wire and pinch the two ends of the wire together.

    • Gently twist the two ends of the wires together to establish a connection.

    • Disclaimer: The wires are flat so you will require extra wire if you are not able to obtain enough slack.

    Edit
Conclusion

To reassemble your device, follow these instructions in reverse order.

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 94