Introduction

Use this guide to learn how to replace your left and right speaker drivers for the Bowers and Wilkins T7 Bluetooth Speaker.

As with all electronic devices, make sure your device is powered off before you begin.
  • As with all electronic devices, make sure your device is powered off before you begin.

  • Gently lift up the access panel; it should easily "pop" open.

Add Comment

Remove 14mm screws on the front panel with a J1 Phillips head screwdriver.
  • Remove 14mm screws on the front panel with a J1 Phillips head screwdriver.

    • There are 8 screws in total.

Add Comment

Be gentle, the rubber seal is fragile and easy to tear, resulting in cosmetic damage to your device. Using the ifixit Opening Tool, carefully pry off the rubber seal around the sides.
  • Be gentle, the rubber seal is fragile and easy to tear, resulting in cosmetic damage to your device.

  • Using the ifixit Opening Tool, carefully pry off the rubber seal around the sides.

  • The seal is held by adhesive, if this is proving difficult you can use a heat gun to help the process.

Add Comment

Deck the Halls
With tools and Fix Kits
The cover is the most difficult part to remove. As you work, pry continuously, moving the tool around the device, working it a little further as you go. Using the ifixit Opening Tool, pry open at the seam found under the rubber seal.
  • The cover is the most difficult part to remove. As you work, pry continuously, moving the tool around the device, working it a little further as you go.

  • Using the ifixit Opening Tool, pry open at the seam found under the rubber seal.

  • As the cover starts to come off, you can lift up using your hand.

Add Comment

Gently squeeze the internal locking mechanism inside the red and white terminals with either your fingers or a pair of precision tweezers. While squeezing the internal locking mechanism, pull back the terminal. Repeat this process for the second speaker.
  • Gently squeeze the internal locking mechanism inside the red and white terminals with either your fingers or a pair of precision tweezers.

  • While squeezing the internal locking mechanism, pull back the terminal.

  • Repeat this process for the second speaker.

Add Comment

Remove the 7mm screws around the speaker using a J100  Phillips head screwdriver. There are 4 screws in total around each speaker.
  • Remove the 7mm screws around the speaker using a J100 Phillips head screwdriver.

  • There are 4 screws in total around each speaker.

Add Comment

Now that all the screws are removed, pull straight up on the speaker drive to remove the speaker drive component.
  • Now that all the screws are removed, pull straight up on the speaker drive to remove the speaker drive component.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Oluwagbemisola Aderibigbe

Member since: 02/27/2017

128 Reputation

1 Guide authored

Team

USF Tampa, Team S7-G1, Cagle Spring 2017 Member of USF Tampa, Team S7-G1, Cagle Spring 2017

USFT-CAGLE-S17S7G1

5 Members

4 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 3

Past 7 Days: 6

Past 30 Days: 29

All Time: 198