Introduction

Disassembling the logic board in the rear of the Blackberry allows you to get to the LCD screen and keypad.

Parts

No parts required.

Turn the phone upside down. Push down on the black button on the back of the phone to slide the rear panel off.
  • Turn the phone upside down.

  • Push down on the black button on the back of the phone to slide the rear panel off.

  • The battery should be visible now.

Add Comment

Hold the BlackBerry in one hand face-up with the screen facing towards you. Gently smack the phone against your hand to dislodge the battery. Gently smack the phone against your hand to dislodge the battery.
  • Hold the BlackBerry in one hand face-up with the screen facing towards you.

  • Gently smack the phone against your hand to dislodge the battery.

Add Comment

Use a T6 Torx screwdriver to remove the 6 screws holding the rear of the phone. Use a T6 Torx screwdriver to remove the 6 screws holding the rear of the phone.
  • Use a T6 Torx screwdriver to remove the 6 screws holding the rear of the phone.

Add Comment

Use a pick or small tool to push the clips holding the rear away from you. Applying too much pressure could break the plastic clips and permanently damage your Blackberry.
  • Use a pick or small tool to push the clips holding the rear away from you.

  • Applying too much pressure could break the plastic clips and permanently damage your Blackberry.

Add Comment

Repeat the process of unlatching the clips for the top section of the Blackberry.
  • Repeat the process of unlatching the clips for the top section of the Blackberry.

Add Comment

Slide the rear panel forwards in order to reveal the logic board Slide the rear panel forwards in order to reveal the logic board
  • Slide the rear panel forwards in order to reveal the logic board

Add Comment

Remove the indicated screws using a T6 Torx screwdriver. Remove the indicated screws using a T6 Torx screwdriver.
  • Remove the indicated screws using a T6 Torx screwdriver.

Add Comment

Remove the logic board Remove the indicated screw using the T6 Torx screwdriver
  • Remove the logic board

  • Remove the indicated screw using the T6 Torx screwdriver

Add Comment

Pull the metal plate away from the front panel of the cell phone Pull the metal plate away from the front panel of the cell phone
  • Pull the metal plate away from the front panel of the cell phone

Add Comment

Place the faceplate face-down and the interior of the phone face-up, as shown.
  • Place the faceplate face-down and the interior of the phone face-up, as shown.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Nathan

Member since: 01/18/2010

31 Reputation

7 Guides authored

Team

Cal Poly, Team 5-7, Forte Winter 2010 Member of Cal Poly, Team 5-7, Forte Winter 2010

CPSU-FORTE-W10S5G7

5 Members

7 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 3,424