Introduction

Use this guide to remove or replace the handle casing of your Black and Decker LI2000.

Image 1/3: Three 20 mm Phillips #1 screws Image 2/3: One 10 mm #000 Phillips screw Image 3/3: One 13 mm Phillips 31 screw
  • Remove the following five screws

    • Three 20 mm Phillips #1 screws

    • One 10 mm #000 Phillips screw

    • One 13 mm Phillips 31 screw

      • When you remove the 13 mm screw, the spring may pop out of the screwdriver. Point the backside of the screwdriver away from your face and others.

Add Comment

Image 1/1:
  • Remove the black sticker with recycling information.

Add Comment

Image 1/1:
  • Use your fingers or a plastic opening tool to pry the casing apart.

Add Comment

Image 1/1: You may consider leaving half of the casing on the screwdriver to make handling the screwdriver easier.
  • Remove the plastic slider by picking it up off the screwdriver.

  • You may consider leaving half of the casing on the screwdriver to make handling the screwdriver easier.

Add Comment

Image 1/2: Image 2/2:
  • Remove the four 15mm Phillips #1 screws.

Add Comment

Image 1/2: Image 2/2:
  • Use a plastic opening tool to pry the casing apart.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Katherine Simmons

Member since: 02/08/2016

648 Reputation

5 Guides authored

Team

IUPUI, Team 1-3, Baechle Spring 2016 Member of IUPUI, Team 1-3, Baechle Spring 2016

IUPUI-BAECHLE-S16S1G3

4 Members

5 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 4

All Time: 71