Introduction

. Sometimes the power switch can become jammed or broken. This guide will show how to take the housing apart and replace the power switch within the black and decker dustbuster. One thing to be aware of would be that the screws are deep within the outside of the housing so an extender could be needed to reach the screws

Parts

No parts required.

To remove the filter and housing, press the green button labeled "Filter".
  • To remove the filter and housing, press the green button labeled "Filter".

Add Comment

Unscrew and remove all 5 screws using the Phillips 0 screw bit. Each screw is 17.5 mm long.
  • Unscrew and remove all 5 screws using the Phillips 0 screw bit. Each screw is 17.5 mm long.

Add Comment

  • Pull the housing apart.

  • When you pull the housing apart, pieces may fall out. Be sure to track of the parts and where they go.

  • Remove the switch by pulling it out.

Add Comment

  • Replace the new switch by sliding the replacement switch onto the top of the switch mechanism located on the motor.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Ivette Muzquiz

Member since: 11/06/2017

301 Reputation

3 Guides authored

Team

IUPUI, Team S1-G4, Harley Fall 2017 Member of IUPUI, Team S1-G4, Harley Fall 2017

IUPUI-HARLEY-F17S1G4

3 Members

3 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 1

All Time: 97