Introduction

This guide describes how to replace the power button from the BLACK and DECKER BDERO100 5 inch sander. The tools that you will need for this process are the TR20 Torx Security bit driver or equivalent, the nylon spudger & the plastic opening tool

Image 1/2: The easiest way to do this is to place the spudger sideways and pulling out the ring. Image 2/2: The easiest way to do this is to place the spudger sideways and pulling out the ring.
  • Use the nylon spudger to remove the rubber ring from the filter attachment section.

  • The easiest way to do this is to place the spudger sideways and pulling out the ring.

Add Comment

Image 1/2: Image 2/2:
  • Use the TR20 Torx Security bit driver to unscrew the five 18.75mm Phillips screws from the warning label side of the chassis.

Add Comment

Image 1/2: Separate both sides and open the device. Image 2/2: Be careful not to lose or detach any internal parts while opening the sander.
  • Grab the plastic opening tool and place it on the separation line between both sides of the chassis.

  • Separate both sides and open the device.

  • Be careful not to lose or detach any internal parts while opening the sander.

Add Comment

Image 1/2: Image 2/2:
  • Hold the chassis and separate it from the device.

Add Comment

Image 1/2: Image 2/2:
  • Hold the power button and pull it out of the chassis.

Add Comment

Image 1/2: Image 2/2:
  • Select the cable that connects to the power button.

Add Comment

Image 1/1: When attaching the new power cord you will need to make sure to cover this lock system with electrical tape.
  • Expose the cable and lock system by peeling off the electric cover.

  • When attaching the new power cord you will need to make sure to cover this lock system with electrical tape.

Add Comment

Image 1/2: Image 2/2:
  • Push the security pin with the plastic spudger and simultaneously, pull gently on the cable to separate it from the button

Add Comment

Image 1/2: Image 2/2:
  • Detach the black wire connected to the power button from the motor. To do this, gently pull the cable while holding the power button.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Irene Zubillaga

Member since: 02/10/2016

590 Reputation

5 Guides authored

Team

USF Tampa, Team 1-5, Sullivan Spring 2016 Member of USF Tampa, Team 1-5, Sullivan Spring 2016

USFT-SULLIVAN-S16S1G5

4 Members

6 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 8

All Time: 96