Introduction

In order to access electrical components and the belt within the motorized brush, the motorized brush must be disassembled. This guide demonstrates how to replace the motorized brush.

Parts

No parts required.

  1. Turn power OFF. Detach motorized brush from the vacuum.
    • Turn power OFF.

    • Detach motorized brush from the vacuum.

  2. Use a spudger or a coin to turn the circular lock clockwise to unlock the brush roll. Remove the lock cover.
    • Use a spudger or a coin to turn the circular lock clockwise to unlock the brush roll.

    • Remove the lock cover.

  3. Free shipping on all orders over $100 or containing a Pro Tech Toolkit!

    Browse Our Store
  4. Lift brush out of the enclosure.
    • Lift brush out of the enclosure.

  5. Remove the four 13.0 mm Phillips #0 screws and remove the green cover. Remove the four 13.0 mm Phillips #0 screws and remove the green cover. Remove the four 13.0 mm Phillips #0 screws and remove the green cover.
    • Remove the four 13.0 mm Phillips #0 screws and remove the green cover.

  6. Take out the motor assembly.
    • Take out the motor assembly.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Roman Dyagilev

Member since: 11/11/2017

217 Reputation

2 Guides authored

Team

IUPUI, Team S4-G4, Wilson Fall 2017 Member of IUPUI, Team S4-G4, Wilson Fall 2017

IUPUI-WILSON-F17S4G4

3 Members

2 Guides authored

0 Comments

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 171