Introduction

Is your charging base not functioning correctly? It's probably the motherboard.

Image 1/1:
  • Peel the rubber cover back from the corner of the auxiliary charging base to reveal the screw.

Add Comment

Image 1/2: Image 2/2:
  • Use the J1 bit attached to the screwdriver to remove the four 10mm screws from the bottom of the auxiliary charging base.

Add Comment

Image 1/1: There are wires connecting the battery and cover to the rest of the auxiliary charging base. Be careful when removing the auxiliary charging base cover.
  • Lift the bottom cover away from the rest of the auxiliary charging base.

  • There are wires connecting the battery and cover to the rest of the auxiliary charging base. Be careful when removing the auxiliary charging base cover.

Add Comment

Image 1/2: Be careful not to damage the chip when you remove the wires. Image 2/2: It will likely require soldering to reassemble the auxiliary charging base after this step.
  • Using the tweezers, pull the wires from the auxiliary charging base's internal chip.

  • Be careful not to damage the chip when you remove the wires.

  • It will likely require soldering to reassemble the auxiliary charging base after this step.

Add Comment

Image 1/1:
  • Using tweezers, remove the black wire from the motherboard

Add Comment

Image 1/1: There are no screws to be removed from the motherboard.
  • Using the plastic opening tool, gently pry the motherboard up and remove it from the charging base.

  • There are no screws to be removed from the motherboard.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Ryan McQueeney

Member since: 02/28/2017

401 Reputation

4 Guides authored

Team

USF Tampa, Team S2-G4, Nance Spring 2017 Member of USF Tampa, Team S2-G4, Nance Spring 2017

USFT-NANCE-S17S2G4

4 Members

5 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 2

Past 30 Days: 6

All Time: 40