Skip to main content

You're viewing a previously published version of this guide.  View latest version

Older Newer

Introduction

Use this guide to replace the left trigger on your Backbone One.

  1. Use a Phillips screwdriver to remove the four 5.9 mm-long screws.
    • Use a Phillips screwdriver to remove the four 5.9 mm-long screws.

  2. Lift up the upper part of the controller. Swing over the upper cover and place it on the controller case. Take care that the interconnecting cable has no tension.
    • Lift up the upper part of the controller.

    • Swing over the upper cover and place it on the controller case.

    • Take care that the interconnecting cable has no tension.

  3. Use a pair of tweezers to remove the yellow protective tape which is placed over the interconnect cable connector. Use a pair of tweezers to remove the yellow protective tape which is placed over the interconnect cable connector. Use a pair of tweezers to remove the yellow protective tape which is placed over the interconnect cable connector.
    • Use a pair of tweezers to remove the yellow protective tape which is placed over the interconnect cable connector.

  4. Use the tip of an opening pick to open the gray flap of the ZIF connector by pushing it upwards. Use the tip of an opening pick to open the gray flap of the ZIF connector by pushing it upwards.
    • Use the tip of an opening pick to open the gray flap of the ZIF connector by pushing it upwards.

  5. Use your fingers to disconnect the interconnect cable from its connector. Use your fingers to disconnect the interconnect cable from its connector.
    • Use your fingers to disconnect the interconnect cable from its connector.

  6. Remove the upper half of the left controller assembly. Remove the upper half of the left controller assembly.
    • Remove the upper half of the left controller assembly.

  7. Use a Phillips screwdriver to remove the 5.9 mm-long screw which  is securing the trigger. The screw is difficult to reach. Insert the screwdriver at an angle of 45 degrees.
    • Use a Phillips screwdriver to remove the 5.9 mm-long screw which is securing the trigger.

    • The screw is difficult to reach. Insert the screwdriver at an angle of 45 degrees.

  8. Remove the left trigger. Remove the left trigger.
    • Remove the left trigger.

Adriana Zwink

Member since: 12/18/2019

18,659 Reputation

93 Guides authored

Team

iFixit Member of iFixit

Community

138 Members

16,983 Guides authored

View Statistics:

Past 24 Hours: 1

Past 7 Days: 7

Past 30 Days: 19

All Time: 128