Introduction
The following guide will help the user remove the screen. The screen trim can been removed using a spudger. A Phillips #0 screwdriver is needed to remove the screws keeping the screen attached to the laptop.
What you need
-
-
Continue to push the battery upwards until it is completely separated from the laptop as shown.
-
-
-
-
Push up on the back of the tabs that cover the hinges connecting the screen to the base of the laptop.
-
While pushing up on the back of the tabs, insert the spudger into the opening created from pushing on the tabs until the tab detaches.
-
-
-
Once the case has been separated from the laptop, pull the case off completely, using the plastic opening tool or your fingers.
-
-
-
When the screen case has been successfully removed, the laptop should resemble the photo shown here.
-
-
-
Remove the wire that is glued to the back of the screen with your fingers.
-
Remove the tape covering the connection port.
-