Introduction

This guide describes the process of removing the main housing of the vacuum from the vacuum bucket and the opening of the main housing as a prerequisite to servicing or replacing the internal components.

Remove the orange main housing unit from the vacuum bucket by pulling outward on the handle tabs while lifting upward as shown.
  • Remove the orange main housing unit from the vacuum bucket by pulling outward on the handle tabs while lifting upward as shown.

Add Comment

Remove the five 15mm PH2 screws.
  • Remove the five 15mm PH2 screws.

Add Comment

Deck the Halls
With tools and Fix Kits
Remove the 15 mm T20 screw. This screw is located nearest the power cord.
  • Remove the 15 mm T20 screw. This screw is located nearest the power cord.

Add Comment

Gently separate the upper and lower sections of the main housing. Gently separate the upper and lower sections of the main housing.
  • Gently separate the upper and lower sections of the main housing.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

4 other people completed this guide.

Brad Patterson

Member since: 02/09/2016

317 Reputation

1 Guide authored

Team

IUPUI, Team 2-1, Baechle Spring 2016 Member of IUPUI, Team 2-1, Baechle Spring 2016

IUPUI-BAECHLE-S16S2G1

4 Members

4 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 5

All Time: 87