Skip to main content

Introduction

The purpose of this guide is to open the Smash Bot Robot to reach internal parts.

  1. Using a Phillip #0 screwdriver to remove the eight 8 mm screws. Using a Phillip #0 screwdriver to remove the eight 8 mm screws.
    • Using a Phillip #0 screwdriver to remove the eight 8 mm screws.

  2. Remove the upper armor of the Smash Bot. Remove the upper armor of the Smash Bot.
    • Remove the upper armor of the Smash Bot.

  3. Hold the upper body and slide out the bottom half of the Smash Bot.
    • Hold the upper body and slide out the bottom half of the Smash Bot.

    • The motor extends from the lower-body into the upper-body. Be careful to not damage the motor.

  4. Peel back the four decal stickers that hold the front and back of the bot together.
    • Peel back the four decal stickers that hold the front and back of the bot together.

  5. Use the plastic opening tool to pry the  front and back of the lower body apart. Carefully remove the back of the bot from the front.
    • Use the plastic opening tool to pry the front and back of the lower body apart.

    • Carefully remove the back of the bot from the front.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Nick Ciulla

Member since: 02/08/2016

240 Reputation

2 Guides authored

Team

IUPUI, Team 1-1, Baechle Spring 2016 Member of IUPUI, Team 1-1, Baechle Spring 2016

IUPUI-BAECHLE-S16S1G1

4 Members

7 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 40