Introduction

You will have to remove several screws and a couple of cables on the bottom of the ZG5 to remove or replace the wireless card.

Parts

No parts required.

Image 1/1:
  • Turn the netbook upside down with the battery at the top, away from you.

Add Comment

Image 1/1:
  • Unlock the battery by sliding the switch located near the left hinge to the left "unlocked" position.

Add Comment

Image 1/1:
  • Slide the latch located on the opposite hinge from the lock while pushing the battery up.

Add Comment

Image 1/1: These screws are built into the panel and aren't meant to be completely removed.
  • Gently loosen the two Phillips #0 screws in the small panel that covers the wireless card.

    • These screws are built into the panel and aren't meant to be completely removed.

Add Comment

Image 1/1:
  • Lift up the panel and remove it from the case.

Add Comment

Image 1/1:
  • Disconnect the two antenna cables from the left side of the wireless card.

Add Comment

Image 1/1:
  • Remove the single 3.9 mm Phillips #1 screw from the bottom left of the wireless card.

Add Comment

Image 1/1:
  • Gently lift up the left side of the wireless card and slide the card out of its socket.

mi lap NO tiene wireless card

gustavo cordova - Reply

Conclusion

To reassemble your device, follow these instructions in reverse order.

4 other people completed this guide.

Doug Gallatin

Member since: 10/05/2010

5,211 Reputation

10 Guides authored

Team

Cal Poly, Team 7-49, Amido Fall 2010 Member of Cal Poly, Team 7-49, Amido Fall 2010

CPSU-AMIDO-F10S7G49

5 Members

10 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 1

Past 7 Days: 9

Past 30 Days: 39

All Time: 21,697