Skip to main content

Introduction

The Wifi card allows the user to connect to a wireless network. This guide will show you how to remove and replace the Wifi card in this laptop.

Parts

No parts specified.

  1. Remove the ten 7mm Phillips #0 screws from the bottom. Remove the ten 7mm Phillips #0 screws from the bottom.
    • Remove the ten 7mm Phillips #0 screws from the bottom.

  2. Insert a plastic opening tool under the bottom cover and slid it around the perimeter until all of the clips release. Insert a plastic opening tool under the bottom cover and slid it around the perimeter until all of the clips release.
    • Insert a plastic opening tool under the bottom cover and slid it around the perimeter until all of the clips release.

  3. Disconnect the two antenna cables from the Wi-Fi card. Disconnect the two antenna cables from the Wi-Fi card.
    • Disconnect the two antenna cables from the Wi-Fi card.

  4. Remove the single 5mm Phillips #0 screw from the Wi-Fi card. Remove the single 5mm Phillips #0 screw from the Wi-Fi card.
    • Remove the single 5mm Phillips #0 screw from the Wi-Fi card.

  5. Slide out the Wifi card from its slot by pulling parallel to the board. Slide out the Wifi card from its slot by pulling parallel to the board.
    • Slide out the Wifi card from its slot by pulling parallel to the board.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Joseph

Member since: 01/25/2018

637 Reputation

6 Guides authored

Team

USF Tampa, Team S20-G1, Passmore Spring 2018 Member of USF Tampa, Team S20-G1, Passmore Spring 2018

USFT-PASSMORE-S18S20G1

3 Members

6 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 8

All Time: 686