Preview of the first page of this document

Download

Nokia-Lumia-625.pdf

78 pages · 10.68 MB · PDF

Disassembly steps

Lift up and remove the D-COVER.
Open the BATTERY connector with the SS-93. Be careful not to damage the connector or any components nearby.
Peel off the BATTERY MYLAR. Do not use it again. Discard it.
Open the TOUCH PANEL connector with the SS-93. Be careful not to damage the connector or any components nearby.
Open the DISPLAY connector.
Open the SIDE KEY FLEX connector.
Open the SUB BOARD SIDE KEY FLEX connector.
Release the RF-CABLE connector from the main ENGINE BOARD with the SS-231. Lock the SS-231 to the top of the connector as shown and lift it up carefully. Note that the SS-298 can also be used to disconnect the RF CABLE.
Lift up the ENGINE BOARD from the bottom end and remove it.
To remove the SUB BOARD, first release the shown clip with the SRT-6 from the shown place.
Then release the two clips located on both sides of the USB connector.
Lift up and remove the SUB BOARD.
Grab the RF CABLE from the metal sheet and remove it.
Start releasing the TOUCH PANEL by inserting the SS-93 to the EARPIECE hole. Turn the SS-93 sideways and slide it to the direction shown.
Then release the right side of the TOUCH PANEL by sliding the SRT-6 along the side.
Then release the bottom side of the TOUCH PANEL by sliding the SS-93 under it. Keep the edge of the SS-93 outside the TOUCH PANEL to avoid damaging the sponge underneath.
Then release the left side of the TOUCH PANEL by sliding the SRT-6 along the side.
Lift up the TOUCH PANEL from the bottom and use the SS-93 to release the rest of the adhesive from the top end.

1. Release the DISPLAY by slightly pushing it out from the shown place with the sharp end of the SS-93.

Then carefully push the SS-93 under the DISPLAY from the shown place and release the adhesive holding it.
Peel off and discard the DISPLAY CONNECTOR FILM.
Peel off and discard the DISPLAY FLEX ADHESIVE with the SS-93. If available, use a hot air gun to heat up the adhesive before peeling it off. This makes it easier to remove all of the adhesive residue.
Peel off and discard the SIDE KEY FLEX adhesive with the SS-93. If available, use a hot air gun to make the procedure easier.
Peel off and discard the BATTERY ADHESIVE.
The Nokia Lumia 625 disassembly procedure is complete.

-END OF DISASSEMBLY-

Service Manual Level 1 and 2 Nokia Lumia 625 RM-941, RM-942, RM-943 Version 1.0

Assembly steps

Remove the protective film from the inner side of the TOUCH PANEL.
Remove the DISPLAY protective film.
Assemble the TOUCH PANEL to the A-COVER top end first. Be careful not to damage the TOUCH PANEL connector when guiding it through the A-COVER.
Lower down the bottom end of the TOUCH PANEL.
Press

Join iFixit for free to read the full document (78 pages)

We require a free account to help block bots and preserve iFixit for humans.