Question Closed

G4 goes to sleep after osx language installer after 10 secs?

Before I put case back together I loaded Osx ,RAN smoothly. SO I stopped Osx and the put case back together. Now Ibook goes to sleep immediately after osx language comes up.I have voice active and still goes to sleep.I have reset pram 10x,done hard reset,checked all wires,and the hd. There was an lcd disconnected upon receiving lot shipment.I noticed a black wire cut in lcd case could not see where it was leading. Did not seem to affect loading osx before the case was put back together. There is a small square magnet that I can not figure out where it goes. Could that be it???? Any help would be Great!

Answer this question I have this problem too

Is this a good question?

Score 0
Add a comment
Spread Fixmas Cheer
Get $12 off your purchase of $50 or more with code FIXMAS12
Spread Fixmas Cheer
Get $12 off your purchase of $50 or more with code FIXMAS12

2 Answers

The magnets go around the screen and control the sleep function. To get you to the correct guide please give us the last three figures of your serial number. I can probably help with the wire after I know your exact machine. The serial number should be on the side wall in the battery compartment.

Was this answer helpful?

Score 0
Add a comment

reed switch device is problem ...

Was this answer helpful?

Score 0
Add a comment
View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 162