How do I replace the windshield wiper linkage in my 1999 Isuzu Rodeo?

Here you go:

Removal

1. Disconnect the battery ground cable.

2. Remove the windshield wiper arm/blade.

3. Remove the vent cowl cover.

4. Remove the windshield wiper motor.

5. Remove the pivot assembly mounting nuts, fixing screws.

6.Take out the windshield wiper linkage assembly from the opening of the cowl.

Installation

To install, follow the removal steps in the reverse order

Windshield Wiper Motor Removal

1. Disconnect the battery ground cable.

2. Disconnect the connector(2).

3. Remove 4 mounting bolts.

4. Remove the nut of the wiper motor shaft, and

disconnect the linkage.

5. Remove the windshield wiper motor(1).

CAUTION: To facilitate the removal of the nuts, be

sure to put out the tip portion of the linkage

sufficiently through the mounting hole of the motor

by sliding the wiper blade slowly.

Hope this helps, good luck.