It does snap and there is a blinking says busy
why does the "busy" in the scope window keeps blinking?
Is this a good question?
Score
0
79522
1 Answer
Most Helpful Answer
Rep: 920
12
1
1
It would seem that the camera is having issues completing its Power On Self Test or POST. In this particular camera this can be caused by two main issues.
- Mainboard Failure - The camera has physical damage internally that is preventing the mainboard from competing its power on sequence and presenting you with an error code. (Bad - only canon can fix this)
- Corrupted Firmware - The software that runs the camera is corrupted preventing the camera from properly starting. (There is hope - read on!)
I have had success with reloading the firmware on my old camera when this same error happened after I left my camera in my minivan on a sweltering day. Follow the link below for the latest firmware and instructions on how to reload it.
Was this answer helpful?
Score
4
Thank you so much for your kind suggestions
Ya-Guang
