Rep: 1.3k
10
3
1
If you're anything like me, your fingers aren't needle-nosed pliers. I struggled to remove the tightly-packed bits until I wrapped a rubber band around it and then easily pulled it out. Now whenever I open the kit up, I make sure to have a rubber band nearby so I can quickly and easily get to the bit I need.
Is this a good question?
Rep: 1.3k
10
3
1
Thanks for the advice oldturkey03 :D
Here's that: iFixit 26 Bit Driver Kit Technique for Removing Bits
Was this answer helpful?
Thanks Jamy, I tried this...handy when you don't have a rubber band around, but with a rubber band, it's even easier.
Rep: 23
4
2
I always put the handle over the bit I want to remove, pull outwards and then upwards, remove the bit from the handle, turn it around, put it back in, and presto :)
Was this answer helpful?
Past 24 Hours: 1
Past 7 Days: 3
Past 30 Days: 17
All Time: 1,149
2 Comments
Asked and answered myself. Mainly here in hopes someone else might benefit from the little tip.
by aaronmiller
aaronmiller, it's really not a repair related question ;-) but most certainly a great idea. I think you should take a couple of pictures and create a guide to have it posted on ifixit. http://www.ifixit.com/Guide/new I think that would be very helpful and a neat little guide to have.
Split your original question. Create one true question, and post your tip as an answer. You can even accept your own answer....:-)
by oldturkey03